Rep 10.16 Fuser Pressure Roller And Bearings - Xerox Phaser 4600 Service Manual

Figure 13 Remove the Heat Roller and Bearings
4 Repairs and Adjustments
REP 10.15, REP 10.16

REP 10.16 Fuser Pressure Roller and Bearings

Parts List on PL 10.11 Item 3
Removal
This procedure lists steps to remove the Pressure Roller and Bearings from the Fuser. A spring
hook is recommended for this procedure.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not touch the Fuser while it is hot.
Fuser plastic and metal components are easily over stressed, bent, or broken. Use care when
releasing hooks that secure Fuser covers and guides.
1. Remove the Rear Door, REP
2. Remove the Fuser, REP 10.10.
3. Remove the Fuser Heat Roller and Bearings.
4. Release the right cam follower spring.
5. Remove 2 screws with washers (1 metal, 1 plastic) that secure the cam follower to the
Fuser, Figure 1.
04/2016
4-114
WARNING
WARNING
CAUTION
28.6.
REP 10.15.
Phaser 4600/4620/4622 Printer Service Manual
Revised