Rep 1.5 Smps - Xerox Phaser 4600 Service Manual

REP 1.5 SMPS

Parts List on PL 1.10 Item 2
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not touch the Fuser while it is hot.
1. Remove the Duplex Unit, REP 10.1.
2. Remove the Waste Toner Cartridge.
3. Remove the Left Cover, REP 28.3.
4. Remove the IP Board Cover, REP
5. Remove the Right Cover, REP 28.2.
6. Remove the IP Board Cage, REP 3.5.
7. Remove the Rear Door, REP 28.5.
8. Remove the Fuser, REP 10.10.
9. Remove 5 screws (2 plastic, 3 metal) that secure the bottom fuser bracket to the chassis,
Figure 1.
Figure 1 Remove the bottom fuser bracket
10. Disconnect CN6 from the MCU Board,
11. Release the ribbon cable from the guide and remove 1 screw (metal) that secures the
guide to the MCU Board bracket, Figure
Revised
Phaser 4600/4620/4622 Printer Service Manual
WARNING
WARNING
28.1.
Figure 2.
2.
Figure 2 Remove the cable guide
12. Remove 2 screws (metal) that secure the right side of the power supply tray to the chas-
sis, Figure 3.
Figure 3 Remove the right side power supply tray screws
04/2016
4-7
4 Repairs and Adjustments
REP 1.5