Deleting Data And Reconnecting The Remaining Data (Track Cut) - Boss BR-1180 Owner's Manual

Editing the performance—Track Editing
At this time, you can select "DISP" and press [ENTER] to
switch between methods of specifying the location
(measures, time).
Set the following items.
START (start point):
Specify the location at which the blank will be inserted.
LEN (Length):
Specify the length of the blank.
* If, after specifying the above items as time locations, you then
switch to the measure display, a "+" symbol may appear,
indicating that the currently displayed locations are different
than the actual locations. If you are specifying these items as
measure locations, you can eliminate this discrepancy by using
the TIME/VALUE dial in measures screen to specify the
location.
7. When you have finished making settings, use
[CURSOR] to move the cursor to the "GO," and press
[ENTER].
The blank will be inserted.
8. Press [EXIT] several times to return to the top screen.
Deleting data and reconnecting
the remaining data (Track Cut)
This deletes the recorded data in a specified range.
When this operation is used to cut the recorded data, any
recorded data located after the region that was cut will be
moved toward the beginning of the song to close the gap.
If we use the analogy of a tape recorder, this is like using
scissors to cut out a section of the audio tape, and then
splicing the two ends together.
fig.R10-29
START
* Do not leave any sound that is under 0.5 seconds in duration
before or after the range being cut. Sound of a duration that is
less than 0.5 seconds will be inaudible, even though it still
exists in the data.
1. Press [UTILITY].
72
A
END Time
2. Use [CURSOR] to select the "TRACK" icon, and press
[ENTER].
fig.R10-04
3. Use [CURSOR] to select the "CUT" icon, and press
[ENTER].
fig.R10-30
The Track Cut screen appears, allowing you to select the
track/V-track from which recorded data will be cut.
4. Use [CURSOR] and the TIME/VALUE dial to select the
track/V-track from which data will be cut.
* If a name has been assigned to the selected track, the track
name will be displayed.
fig.R10-31
(tracks/V-tracks)
track name
5. If there are other tracks from which you wish to cut
data using the same settings (range), press CURSOR
[ ] several times to move the cursor to the following
location, and rotate the TIME/VALUE dial.
track