Display - Boss BR-1180 Owner's Manual

Display

fig.00-23
1 2
5
Displays the menu screen, parameter setting screen, or other
information, depending on the type of settings being made.
If the screen is difficult to view, see "Adjusting the Display
Contrast" (p. 139).
1. MARKER
This indicates the marker number of the current location. If
no marker has been assigned to the current location, the
number of the previous marker is shown.
In addition, "- - -" is displayed when the current location is
earlier than the point at which the marker numbered "001" is
set, or when no markers have been set.
2. MEASURE
Displays the measure number and beat of the current
position within the song. The left number is the measure
number, and the right number is the beat.
3. TIME
The time of the current location in the song is displayed as
"** hours ** minutes ** seconds."
3 4
6 7
4. FRAME
Displays the frame number of the current position of the
song.
At the factory settings, one second is set to 30 frames (non-
drop). This is one type of a specification known as MTC
(MIDI Time Code), and when you use the CDX-1 to play in
synchronization with another MIDI device, you will need to
set both devices to the same MTC type.
"Synchronizing with MIDI devices" (p. 121)
5. INFORMATION
Displays song information (marker names, type of data
recorded, remaining recording time) in PLAY mode.
6. MIXER/TRACK
During play mode, the volume levels of instruments being
input, and volume levels of each track are displayed.
When the BR-1180/1180CD is shipped, this will indicate the
volume level of the volume level of the signal that has passed
through the TRACK faders (post-fader).
If you want to display the volume level of the signal prior to
passing through the faders (pre-fader), refer to "Switching
the signal indicated in the level meter" (p. 133).
7. MASTER
In Play mode, this graphically indicates the volume level of
the signal that has passed through the MASTER fader.
Panel Descriptions
21