Speaker Modeling Parameter Functions; Sp Modeling (Speaker Modeling); Bass Cut Filter - Boss BR-1180 Owner's Manual

Speaker Modeling parameter functions

This function simulates the response of a wide variety of
speakers, ranging from high-quality professional monitor
speakers used in studios around the world, to the speakers of
compact televisions or portable radios.
fig.S04-01
SP Modeling

Bass Cut Filter

Low Freq Trimmer
High Freq Trimmer
Limiter
SP Modeling
(speaker modeling)
Speaker Modeling is adjusted so that the optimal results will
be obtained when you use the Roland DS-90/DS-90A
powered monitors (separately available) as the output
speakers for the BR-1180/1180CD.
Effect On/Off
Turn speaker modeling on/off.
Model
Select the speaker whose characteristics you wish to simulate
(model).
No modeling is to be performed.
Thru:
Modeling will be used to compensate for the
Spr Flat:
DS-90/DS-90A/DS-50A, giving the sound an
even wider range and flatter response.
Pwd. BLK: A standard model of powered monitor (two-
way type, woofer diameter = 170 mm (= 6-1/2
inch)).
Pwd. E-B: Powered monitors characterized by a bright
tone.
Powered monitors characterized by an
Pwd. MAC:
extended low range.
SmlCUBE: Small full-range speakers widely used in
recording studios.
A sealed two-way speaker characterized by its
Wh.CONE:
white woofer, widely used in recording
studios.
WhTISUE: A milder tone produced by covering the
tweeters of the above "Wh.CONE" with tissue
paper.
Radio: A small pocket-type radio.
SmallTV: The speakers of a 14-inch television.
BoomBox: A radio cassette recorder.
160
BoomLoB:
OutputSpeaker
Select the speaker that was actually to connect.
DS-90/A:
DS-50A:
Phase
Specifies the phase of the speakers.
NORMAL:
INVERSE:
Bass Cut Filter
This is a filter that cuts unwanted low range noise, such as
pops.
Effect On/Off
This setting turns the Bass Cut Filter on/off.
Cut Off Freq
OFF, ON
This sets the frequency containing popping or other
undesirable lower-range noises that you want to cut.
A radio cassette recorder with its Low Boost
function turned on.
DS-90/DS-90A is connected.
DS-50A is connected.
The phase will be the same as the input.
The phase will be the opposite of the input.
Thru, 20–2000 Hz
OFF, ON