Editing The Speaker Modeling Settings - Boss BR-1180 Owner's Manual

Reproducing the characteristics of various monitor speakers (Speaker Modeling)
4. Rotate the TIME/VALUE dial to select the speaker
model (patch) you want to use.
The selected speaker model is applied to the output
sound.
For more on the different types of speaker modeling,
refer to the "Speaker Modeling Patch List" (separate
sheet).
5. To turn speaker modeling off, press [EFFECTS] and
select "FX: OFF."
If you want to turn speaker modeling on, press
[EFFECTS] again. "FX: ON" is displayed again.
6. To return to the insert effects settings screen from the
speaker modeling settings screen, press [CURSOR] to
move the cursor to "EXIT SP," then press [ENTER].
At this point, the insert effects are turned on again
automatically.
Editing the speaker
modeling settings
1. First, select the speaker model (patch) for which you
want to change the settings.
2. Use [CURSOR] to move the cursor to "EDIT," then
press [ENTER].
The speaker modeling block diagram is shown
graphically in the display (in EDIT mode).
fig.R06-05
3. Use [CURSOR] to select the various speaker modeling
blocks, and rotate the TIME/VALUE dial to turn a
particular block on or off.
fig.R06-06
4. Use [CURSOR] to move the cursor to the block
containing the parameter you want to edit, then press
[ENTER].
The parameters in the selected block can now be edited.
"Speaker Modeling parameter functions" (p. 160)
5. Use [CURSOR] to select the parameter, and rotate the
TIME/VALUE dial to change the value.
6. If you want to edit other blocks, press [EXIT] to go back
one screen, then repeat Steps 4 and 5.
At this point, pressing CURSOR [
parameter settings screen allows you to move to the
parameter settings screens in other blocks.
7. To save the edited speaker modeling settings, use the
steps in the following section "Saving speaker
modeling settings."
* Any changes you make in the speaker modeling settings are
only temporary. If you exit the EDIT mode without first
saving your changes in the speaker modeling settings, "TMP"
is displayed for the number. Pressing [ENTER] returns you to
the speaker modeling block diagram. For more on the
procedure for writing patches, refer to the following section
"Saving speaker modeling settings." Note that if you select a
new speaker model while "TMP" is displayed, the edited
speaker model reverts to its original settings, and the edited
content is lost.
] [ ] while in the
59