Editing Insert Effect Settings - Boss BR-1180 Owner's Manual

Using the insert effects

Editing insert effect settings

To create a new effect sound, select the patch that most
closely resembles the sound you have in mind from the
effects patches already stored in the unit, then edit its
settings.If you wish to save the effect settings that you edited,
save them as a user patch or song patch.
1. Press [EFFECTS] to access the effect setting screen.
fig.R04-02
2. Press CURSOR [
] to select "Patch Number," then
rotate the TIME/VALUE dial to select the patch.
* At this point, you can press CURSOR [
Name," then rotate the TIME/VALUE dial to call up banks
other than the bank specified with INPUT SELECT.
3. Use [CURSOR] to select the "EDIT," then press
[ENTER].
The connections of the effect will be displayed
graphically (Edit mode).
fig.R04-03
* You can go into Edit mode directly by pressing [ENTER]
while "Patch Number," "Bank Name," or "INSERT" is
selected.
4. Use [CURSOR] to select an effect, and rotate the TIME/
VALUE dial to turn each effect on/off.
fig.R04-04
Effect On
52
] to select "Bank
Effect Off
5. Use [CURSOR] to move the cursor to the effect whose
parameters you wish to modify, and press [ENTER].
Now you can modify the parameters of the selected
effect.
6. Use [CURSOR] to select a parameter, and turn the
TIME/VALUE dial to edit the value.
7. If you would like to edit another effect, press [EXIT] to
return to the previous screen, and repeat steps 5–6.
* At this time, you can use CURSOR [
parameter setting screen to move to the parameter settings of
another effect.
* If you wish to save the current effect settings, perform the
procedure described below in "Saving insert effect settings."
* Edited effect settings are temporary. If you exit Edit mode
without saving the modified patch, the patch number will be
displayed as "TMP." If you press [ENTER] you will return to
the effect connection display screen. For how to save the
changes, refer to "Saving insert effects settings" in the next
section.
Be aware that if you select a new effect patch while
"TMP" is displayed, the altered effect patch is
returned to its original settings and the changes are
lost.
] [ ] in the