How To Record - Boss BR-1180 Owner's Manual

How to Record

Here's how you can use the Repeat function and Auto
Punch-in/out to re-record part of the previously recorded
track 1.
1. Press REC TRACK [1].
The REC TRACK [1] indicator will light alternately in
orange and green.
2. Place the fader for track 1 at the location shown below.
fig.R01-02
3. Press AUTO PUNCH IN/OUT [ON/OFF].
The indicator lights up, showing that the auto punch in
and out have been set.
4. Use the repeat function to repeat the playback of the
song and adjust the volume of the input source using
the INPUT LEVEL knob.
While the song is playing, you can hold down [TRACK
MUTE] and press REC TRACK [1] to mute track 1.
Repeat this to cancel muting.
Listen to the track you will be re-recording and the input
source and adjust the volume of the input source so that
it is the same level as the track.
5. After you have adjusted the volume of the input
source, make sure that muting of track 1 is cancelled.
6. When you are ready to re-record, press [REC] during
repeat playback to begin re-recording.
When you press [REC], recording will occur from the
first-appearing punch-in point to punch-out. Re-record
your performance.
When the song is repeated, you can check the result of
what you just recorded. If the recording is not
satisfactory, press [REC] and perform the recording
again.
7. Press [STOP] to stop recording.
8. Press [REPEAT] to make the button indicator go dark.
9. Press the AUTO PUNCH IN/OUT [ON/OFF], causing
the [ON/OFF] indicator to go out.
10. To delete a segment's punch-in/-out settings, hold
down [DELETE] and press [IN]/[OUT].
Re-recording only a mistake—Punch-in/out
47