Playing Back Audio Cds - Boss BR-1180 Owner's Manual

9. Repeat Steps 5–8. When you have finished registering
all the tracks you intend to write, move the cursor to
"GO," then press [ENTER].
The message "Write Speed?" appears.
fig.R15-71
* If you are in the process of recording a song at this point, the
message "Save Current?" may appear. If you want to save the
current song to the hard disk, press [YES]; press [NO] if you
do not need to save the song. Note, though, that if you do press
[NO], the data currently being recorded will be lost.
10. Rotate the TIME/VALUE dial to set the write speed.
Write Speed:
x2 (352 kbps) Writes twice as fast.
x4 (704 kbps) Writes four times as fast.
x8 (1408 kbps) Writes eight times as fast.
* With some media, the range of write speeds may be limited. In
such cases, the values that can be set with the TIME/VALUE
dial may also be limited.
11. Press [ENTER].
The message "Write Sure?" appears, then press [YES].
"Now Writing..." appears, and writing of the audio CD
begins.
* If the total time of the registered songs exceeds the CD-R/RW
disc's maximum recording time, the message "CD Full!"
appears, and you cannot continue with writing. If this occurs,
reduce the number of registered songs, then proceed with
writing to the disc again.
* To quit while writing to the disc is still in progress, press
[EXIT]. When the message "Cancel?" appears, press [YES];
writing is cancelled (it may take some time after you press
[EXIT] for the message to appear). However, no guarantee can
be made for the utility of the content up to the time writing is
cancelled. Particularly with CD-R discs, note that you may be
unable to use the disc a second time.
* You cannot eject the disc while writing is in progress, even by
pressing the EJECT button.
When "Complete!" appears, the writing is finished.
12. By continuously repeating Steps 8–11, you can write
songs to multiple CD-R/RW discs.
Creating audio CDs (BR-1180CD)
Do not turn off the power or subject the unit to vibration
until writing is finished.

Playing back Audio CDs

You can play back audio CDs on the BR-1180CD.
You can play back not only CD-R discs, but also CD-RW
discs, which cannot be played back on ordinary CD players.
You can also play back audio CDs created with the BR-
1180CD, even before such discs are finalized.
1. Place the audio CD in the CD-R/RW drive.
2. Press [AUDIO CD WRITE/PLAY].
3. Use [CURSOR] to select the "PLAY" icon, then press
[ENTER].
The AUDIO CD playback screen appears.
fig.R15-06
4. Rotate the TIME/VALUE dial to the number of the
track you want to play.
5. Use [CURSOR] to move the cursor to "
[ENTER].
Playback of the track begins, and the track numbers and
times for tracks on the audio CD are displayed.
6. To stop playback, move the cursor to "
[ENTER].
Move the cursor to the symbols displayed on the screen
and press [ENTER] to use the following transport
functions.
: Stops playback of the track.
: Plays back the track. When you press [ENTER]
during playback, you can pause playback.
Press [ENTER] once more to resume playback
from the point where it was stopped.
," then press
," then press
105