Changing The Song Variation; Turning Off The Power - Boss BR-1180 Owner's Manual

Listening to the Demo Songs
Moving through a song in measures or
beats
The current position's measure number and beat number are
displayed at the location labeled "MEASURE" in the display.
1. Select the value that you wish to change.
To move in measure units, use [CURSOR] to select the
number at the left of the MEASURE field.
To move in beat units, select the number at the right of
the MEASURE field.
2. Change the value.
Use the TIME/VALUE dial to select the measure/beat
number to which you want to move.
Specifying and moving marker numbers
The MARKER field of the display shows the marker number
of the current location. If no marker has been registered, this
will indicate " - - - ".
Use [CURSOR] to select the number in the MARKER field,
and use the TIME/VALUE dial to select the marker number
to which you wish to move.

Changing the song variation

In the demo songs, variations of each song are recorded
using the V-Tracks (p. 15). By changing the V-Track, you can
listen to the songs with a different guitar solo, and more.
For information on how to change the V-Track, refer to
"Changing V-Tracks" (p. 48).

(4) Turning off the power

Using the opposite order that you did when turning on the
power (p. 27), turn off the power of each device.
1. keep pressing the POWER switch for more than 2
seconds.
The following message is displayed.
fig.Q01-15
2. If it's all right to turn off the power now, press [YES].
When you press [YES], the user patch data (p. 51) will be
saved internally, so that the current state will be
reproduced the next time the power is turned on.
30
When the save procedure is completed, the power of the
BR-1180/1180CD will be turned off automatically.
(Shutdown)
When recording/editing and when
changing the settings
When the POWER switch of the BR-1180/1180CD is pressed,
it will save the necessary data on disk and in internal
memory, and then will automatically turn off the power. If
any recording/editing operations have been performed, or if
there have been any changes in the mixer parameters, a
screen will appear, asking you whether or not you wish to
save this data.
fig.Q01-16
When you press [YES], the data is saved internally, and the
unit will restore the current conditions the next time the
power is turned on. When you press [NO], all recordings and
edits, changes to the parameters, and other changes are
disregarded.
* If Song Protect (p. 28) is turned on for the current song,
pressing [YES] will cause the display to indicate "Protected
Song! Cannot Save!" Pressing [ENTER] when this occurs
returns you to the top screen, so if you want to proceed with
the save, first release Song Protect (p. 79) then press the
POWER switch again.
You must use the POWER switch to turn off the power
of the BR-1180/1180CD. The recorded data and mixer
settings are not immediately saved when the operation is
performed, but are saved to internal memory when you
save the song or turn off the power.This means that if
you turn off the power by unplugging the AC adaptor,
rather than using the POWER switch, the recorded data
and mixer settings, will be lost.
Before disconnecting the AC adaptor from the outlet,
make sure that the power of the BR-1180/1180CD is
actually off (i.e., that the display screen is dark). Never
disconnect the AC adaptor while data is being saved,
since this will cause the recorded data or editing
contents (mixer settings, effect patch data or the like) to
be lost.