Saving Patch Settings; Copying A Patch - Boss BR-1180 Owner's Manual

Creating audio CDs (BR-1180CD)

Saving patch settings

This assigns a name (patch name) to the edited patch settings
and saves the settings.
1. Entering the patch name.
In the effect block diagram screen, use [CURSOR] to
select "NAME," and press [ENTER].
fig.R15-93
Now you can modify the patch name.
2. Use [CURSOR] and the TIME/VALUE dial to enter the
patch name.
3. When you have finished making settings for each
effect and for the patch name, press [EXIT] to return to
the previous screen (the Mastering Tool Kit block
diagram).
4. Use [CURSOR] to move the cursor to "WRITE," and
press [ENTER].
fig.R15-94
5. Rotate the TIME/VALUE dial to select the writing
destination for the patch.
108
fig.R15-95
* You cannot specify a Preset patch as the write destination.
6. After you've selected the destination, press [ENTER].
After the data has been written, you will return to the
patch select screen.
7. Press [EXIT] several times to return to the top screen.

Copying a patch

When you wish to create several patches with similar
Mastering Tool Kit settings, it is convenient to copy the
patch.
1. Press [REC MODE] a number of times until the
MASTERING indicator lights up.
The Mastering screen appears.
fig.R15-80
2. Press [MASTERING TOOL KIT] to call up the
Mastering Tool Kit selection screen.
* You can also display this screen by pressing [ENTER] in the
Mastering screen.
* You can select this screen by pressing [MASTERING TOOL
KIT] while the REC MODE "INPUT" or "BOUNCE"
indicator is lit.
fig.R15-90
3. Press [CURSOR] to select "Patch Number," then rotate
the TIME/VALUE dial to select a patch.
4. Use [CURSOR] to move the cursor to "COPY," then
press [ENTER].