Menu; Output Select; Display; Play (Play Option) - Boss GT-1 Parameter Manual / Sound List

MENU

OUTPUT SELECT

Specify the device (amp) that's connected to the OUTPUT jacks.
Parameter Value
JC-120
SMALL AMP
COMBO AMP
STACK AMP
SELECT
JC-120 RETURN
COMBO RETURN
STACK RETURN
LINE/PHONES

DISPLAY

Here you can adjust the brightness of the characters in the display.
Parameter Value
CONTRAST 1–16
22
Explanation
Choose this setting if the GT-1 is connected
to the guitar input of a Roland JC-120 guitar
amp.
Choose this setting if the GT-1 is connected
to a small guitar amp.
Choose this setting if the GT-1 is connected
to the guitar input of a combo-type guitar
amp (i.e., a single unit that contains the amp
and speaker) other than the JC-120.
For some types of guitar amps, the "JC-120"
setting might produce better results.
Choose this setting if the GT-1 is connected
to the guitar input of a stack-type guitar amp
(i.e., one in which the amp and speaker are
separate units).
Choose this setting if the GT-1 is connected
to the RETURN jack of the JC-120.
Choose this setting if the GT-1 is connected
to the RETURN jack of a combo-type guitar
amp.
Choose this setting if the GT-1 is connected
to the RETURN jack of a stack-type guitar
amp. You should also choose the "STACK
RETURN" setting if you're using a guitar
power amp together with a speaker cabinet.
Choose this setting if you're using
headphones, or if the GT-1 is connected to a
keyboard amp, mixer, or digital recorder.
Explanation
Higher values increase the brightness.

PLAY (PLAY OPTION)

Here you can specify how the pedals will work during
performance.
Parameter Value
OFF
EXP1 HLD (EXP 1 PEDAL
HOLD),
EXP2 HLD (EXP 2 PEDAL
HOLD)
ON
KNOB LOCK OFF, ON
OFF,
DWN+UP
TUNER,
LOOP,
MEM+1,
UP+CTL1
MEM-1
PEDAL LIGHT OFF, ON
Explanation
The operational status of the EXP
1/2 PEDAL's FUNCTION (p. 17) is
not carried over when patches are
switched.
If the EXP 1/2 PEDAL's FUNC (p. 17)
are the same between 2 patches, the
operational status is carried over when
patches are switched.
For example, if EXP 1/2 PEDAL FUNC is
set to FOOT VOLUME in both patches,
the one before and the one after the
change, the volume corresponding to
the position the pedal is in (angle) at
the time of the patch change will be
maintained after the patch change.
On the other hand, if the patch being
changed to is set to WAH, the volume
will be in accordance with the value
set within the patch, and you'll obtain
a wah effect that is in accordance
with a value that reflects the current
position (angle) of the pedal.
Specifies whether knob operations
will be disabled. If this is ON, knob
operations will be disabled.
Specifies the function when the
[ I ] and [ H ] switches are pressed
simultaneously.
Specifies the function when the [ H ]
and [CTL1] switches are pressed
simultaneously.
Specifies whether the [ I ], [ H ], and
[CTL1] switches are lit or unlit.