Playing Back Repeatedly (Repeat Function) - Boss BR-1600CD Basic Operation Gude

Playing back repeatedly (Repeat Function)

Use the Repeat function to play a certain section of the song
in a repeated fashion.
This function can also be combined with punch-in and punch-
out to carry out loop recording (Owner's Manual; p. 45).
fig.07-09f
1
Move to the song position from which
looped playback is to be started.
2
Press [REPEAT].
[REPEAT] will start to flash and the current position
will be specified as the start position (A) for repeat
playback.
3
Move to the song position at which
playback is to be looped back.
4
Press [REPEAT].
[REPEAT] will start to light up and the current
position will be specified as the end position (B) for
repeat playback.
• A gap of at least 0.5 seconds is required between the start position (A) and the end position (B) for repeat playback. As
a result, (B) cannot be set up at a position within 0.5 seconds of (A).
• Playback is not repeated when the playback is started at a song position after (B).
2,4,5
Basic operation of the recorder
(A)
5
To redo these settings, press [REPEAT]
once again, and turn it off.
In this condition, the start position (A) and end
position (B) for repeat playback have been cleared.
Repeat Steps 1 through 4 to set new positions.
6
Move the current position to a point
before (B) and start playback.
When the song position reaches (B), it will
automatically jump to (A), and the section between
(A) and (B) plays back repeatedly.
(B)
Position
for playback
17