Inactive Replacement - Fujitsu M10-4 Service Manual

7.2.2

Inactive replacement

This section describes the workflows for inactive/hot and inactive/cold FRU
replacement. References to detailed descriptions are written in the workflow. See any
of them as required. You can perform the operations here only for a system with a
building block configuration.
Inactive replacement has the following patterns:
Inactive/hot replacement (for a power supply unit or fan unit)
■
Inactive/hot replacement (for an internal disk or PCIe card)
■
Inactive/cold replacement (building block configuration only)
■
Inactive/hot replacement (for a power supply unit or fan unit)
Inactive/hot replacement can be performed on a power supply unit and a fan unit.
Perform the following procedure to replace the unit.
Chapter 7 Maintenance Flow 145