Fujitsu M10-4 Service Manual page 180

Active/hot addition (for an internal disk)
Active/hot addition can be performed on an internal disk. Perform the following
procedure to install the unit.
Figure 7-16 Active/hot addition flow (for an internal disk)
1. Open rack door
2. Check operating condition of system and
I/O device usage status
3. Install internal disk
4. Check mounting of internal disk
5. Close rack door
Table 7-17 Active/hot addition work procedure (for an internal disk)
Item Work procedure
1 Opening the rack door
2 Checking the operating condition of
the system and the I/O device usage
status
3 Installing an internal disk
4 Checking the mounting of the
internal disk
5 Closing the rack door
166 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023
Installation complete
Reference
"5.3 Checking the Operating Condition and Resource Usage
"10.3 FRU Removal and Installation
"Incorporation of an internal
device"
Flow"
disk" in "6.5.2 Incorporating an I/O
Status"