14.3
Removing the Crossbar Cables
This section describes the procedure for removing the crossbar cables. Enable the
removal of the crossbar cables before attempting to remove them. For details, follow
the procedure in
Caution - Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see
on Static
1.
Remove the two crossbar cables from the SPARC M10-4S.
Remove each crossbar cable by holding the tab (A in
14-7) of the cable and pulling it straight out in the direction of the arrow. At this
time, do not hold the cable part when pulling out the crossbar cable. Pulling the
cable part without the connector lock completely released may cause damage.
Caution - Pulling the cable part without the connector lock completely released may
cause damage.
"Chapter 7 Maintenance
Electricity."
Flow."
Figure 14-6
Chapter 14 Maintaining the Crossbar Cables
"1.5 Precautions
and
Figure
323