Fujitsu M10-4 Service Manual page 163

Table 7-9 Inactive/hot replacement work procedure (for an internal disk or PCIe card)
Item Work procedure
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
3 Checking the operating condition of the
system and the I/O device usage status
4 Powering off the chassis requiring
maintenance
5 Lowering the cable support for maintenance
on a PCIe card
6 Replacing a faulty FRU
7 Securing the cable support after maintenance
on a PCIe card
8 Diagnosing the replacement FRU
9 Confirming that there is no problem with
the replacement FRU
10 Returning the mode switch on the
operation panel to Locked mode
11 Powering on the chassis requiring
maintenance
12 Closing the rack door
Reference
"5.2 Switching the Mode Switch to Service
"5.3 Checking the Operating Condition and Resource
Usage Status"
"5.5 Powering Off the Physical Partition Requiring
Maintenance"
"5.9.2 Lowering the cable
"Chapter 8 Maintaining the PCI Express
"Chapter 10 Maintaining the Internal
"6.1.2 Fixing the cable support"
"6.3.1 Diagnosing the system
"6.3.3 Checking the FRU status after
"6.6 Returning the Mode Switch to Locked
"6.7 Powering On the Physical Partition Requiring
Maintenance"
Mode"
support"
Cards"
Disks"
board"
maintenance"
Mode"
Chapter 7 Maintenance Flow 149