Fujitsu M10-4 Service Manual page 68

Checking the hardware RAID volume status
Check the hardware RAID volume status.
From the control domain or root domain, execute the sas2ircu command of the
SAS2IRCU utility on Oracle Solaris to check for a degraded hardware RAID volume
and a faulty HDD/SSD.
root# ./sas2ircu 0 display
LSI Corporation SAS2 IR Configuration Utility.
Version 19.00.00.00 (2014.03.17)
(Omitted)
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
(Omitted)
IR volume 2
Volume ID
Volume Name
Status of volume
Volume wwid
RAID level
Size (in MB)
Physical hard disks
PHY[0] Enclosure#/Slot#
PHY[1] Enclosure#/Slot#
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #0
(Omitted)
Device is a Hard disk
Enclosure #
Slot #
SAS Address
State
Size (in MB)/(in sectors)
Manufacturer
Model Number
Firmware Revision
Serial No
GUID
Protocol
Drive Type
(Omitted)
*1 RAID volume information
*2 Degraded RAID volume
*3 Physical device information
*4 Indicates a failure
54 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023
(*1)
(*3)
: 286
: 0
: Degraded (DGD) (*2)
: 01a0a262cfe15e62
: RAID1
: 571250
:
: 2:0
: 2:1
: 2
: 0
: 5000039-7-584a-dada
: Failed (FLD) (*4)
: 572325/1172123567
: TOSHIBA
: AL13SEB600AL14SE
: 3703
: X6N0A01PF7TD
: 50000397584adad9
: SAS
: SAS_HDD