Table of Contents
Advertisement
Table 4-22 Active/Cold Replacement Procedure of the XSCF BB Control Cable (continued)
Work
Order
11
12
13
4.3
Inactive/Hot Replacement Workflows
This section describes the workflows for active/hot replacement of the FRUs mounted
in the SPARC M12-2S.
You can perform inactive/hot replacement only in the following configuration:
Building block configuration where two or more physical partitions are operating
■
Before performing replacement work, be sure to check the notes on maintenance
work in the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to inactive/hot replacement:
XSCFU
■
PCIe card
■
PSU
■
FANU
■
HDD/SSD
■
PCI expansion unit
■
4.3.1
Inactive/Hot Replacement Workflow of the XSCFU
You can perform inactive/hot replacement of the XSCFU in the following configuration:
Building block configuration where two or more physical partitions are operating
■
Before replacing the XSCFU, see
"7.1 Precautions for FRU
Table 4-23
Task
Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
Checking the operating condition of the
system and the I/O device usage status
Replacement."
shows the workflow for inactive/hot replacement of the XSCFU.
Reference
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR
DR"
"10.7 Incorporating I/O Resources Into a
Logical
Domain"
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle
"Precautions for XSCFU and PSUBP
Chapter 4 FRU Replacement Workflows
Solaris"
replacement" in
97
Advertisement
Table of Contents
