Figure 5-3 Fixing crossbar cables
Procedure when equipment rack model 16xx is used
a. Remove all the crossbar cables from the crossbar unit.
Note - Record the positions of the cables before removing them to ensure that they are
reinstalled correctly.
b. Remove the hook-and-loop fastener (A in
Figure 5-4 Hook-and-loop fastener of the cable support
c. Use the hook-and-loop fastener to secure the crossbar cables to the cable
98
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ June 2023
securing the crossbar cables.
A
holder installed on the supporting column at the rear of the rack.
Figure
5-4) of the cable support,