Switching The Microsd Card - Fujitsu M10-4 Service Manual

Figure 9-55 Screws for both ends of the XSCF cable connection ports (for the
9.7

Switching the microSD Card

After replacement of the CPU memory unit lower, the firmware version may be
different from the one before the replacement. To use the same firmware version as
that used before the replacement, remove the microSD card from the CPU memory
unit lower being replaced, and then install it in the replacement CPU memory unit
lower.
1. Remove the screw (A in
tape to the removed CPU memory unit lower.
Note - Be careful not to drop the removed screw onto the board of the CPU memory unit
lower.
SPARC M10-4S with a FRAME-A CPU memory unit)
Figure 9-56) securing the microSD card protective
Chapter 9 Maintaining the CPU Memory Unit/Memory 267