Analyzer Status: Factory Settings Hardware; Analyzer Status: Factory Settings Software - Siemens ULTRAMAT 23 Series Equipment Manual

Functions
8.1 Diagnostics
8.1.3

Analyzer status: Factory settings hardware

Base module
UV module
Ser. No.
Revision
Order No.
7MB2335-1ADE3-A001-X
Revision
Ser. no.
Order no.
8.1.4

Analyzer status: Factory settings software

Base module
UV module
Firmware no.:
Softversion:VV.VV.VV
from DD.MM.YY
112
813
: IK-001
: X
:
: AA
: XXXXX
:
A5E12345678
814
A5E35916872
X.X
8141
If the analyzer has a UV module, it has its own object status. In
this case, the adjacent prompt appears first:
If the analyzer does not have a UV module, the following menu
screen (8131) appears immediately with the information on the
hardware of the basic unit.
Factory settings are parameters which are already set on delivery
such as
• Serial No.
• Revision
• Order No.
The hardware configuration and release version can be read
here.
If the device has a UV module, the fabrication number, the object
status and the order number of the UV module can be read out
here.
If the analyzer has a UV module, it has its own firmware version.
In this case, the adjacent prompt appears first:
If the analyzer does not have a UV module, the following menu
screen (8141) appears immediately with the firmware informa‐
tion of the basic unit.
Software shows for each hardware containing firmware:
• The article number of the respective firmware
• The version and creation date of the software and the boot‐
loader number (bottom right of the menu screen)
Equipment Manual, 04/2022, A5E37100388-012
ULTRAMAT 23