Functions; Diagnostics - Siemens ULTRAMAT 23 Series Equipment Manual

Functions

8.1

Diagnostics

In this function group you can view all analyzer data. The menu sequence in the following Fig.
shows all submenus which can be accessed from the "Analyzer status" menu. The arrows lead
by one menu item to the next lower menu level which is called by this menu item.
This display applies to analyzers without an H
The differences when using analyzers with one of these sensors are described in section
Diagnostics: Diagnostics values (Page 105). Dashed lines apply to analyzers with UV module.
Status
Diagnostic values
Fact. settings hard
Fact. settings soft
81
Basic unit
UV module
814
Firmware no.:
A5E12345678
Softversion:VV.VV.VV
from DD.MM.YY 4.4
8142
Firmware no.:
S79610-G210-A900
Softversion:VV.VV.VV
from DD.MM.YY 3.0
8141
Figure 8-1 Overview of diagnostic parameters
This overview contains all parameters of an analyzer that has both an IR detector and a UV
module. If only one of these detectors is present, this overview begins at menu screen 812b (IR)
or menu screen 812c (UV). Parameters marked with a footnote (*) are contained here in the
display for the IR detector. The differences in the display for the UV module are described there
(section Diagnostics: Diagnostic values: UV (Page 107)).
ULTRAMAT 23
Equipment Manual, 04/2022, A5E37100388-012
Basic unit
UV module
813
Revision : AA
Ser. no. : XXXXX
Order no. :
A5E12345678
8132
Ser. no. : XX-XXX
Revision : X
Order no. :
7MBXXXX-XXXXX-XXXX-X
8131
S sensor and without a paramagnetic O
2
O2 Sensor status
Reading : XX.XX mV
Maint.Req.: 6.00 mV
Fault : 5.00 mV
8114
Select component
IR drift readings
XXX AUTOCAL
Deviation: XXXX.XX %
Max.allowed:XXX.XX %
8113
Level 1 required
Flow too low during
AUTOCAL
press ENTER to clear
next message with ->
8111
End of messages
press ENTER to clear
next message with ->
8111a
8
sensor.
2
Logbook/Faults
Maintenance request
AUTOCAL deviation
O2 sensor status
811
Level 1 required
No maintenance
request registered
press ENTER to clear
next message with ->
8112
101