8.3.5.1
Parameters: Pump/LCD contrast: Pump
Pump/flow o.k.
˅ + >: to adjust
ENTER: Save new val.
ESC:
8.3.5.2
Parameters: Pump/LCD contrast: LCD contrast
LCD contrast
˅ + >: to adjust
ENTER: Save new val.
ESC:
Note
Simultaneous pressing of the three keys <↑> , <↓> and <→> sets an average contrast again.
8.4
Configuration
With this function group you can assign relays and inputs/outputs and use special functions and
test functions. The following figure shows the associated menu sequence, further menu
sequences are shown under '842' and '843'. An explanation of the display elements can be found
in section Input mode (Page 95)).
Access to the "Configuration" menu is protected by code level 2.
ULTRAMAT 23
Equipment Manual, 04/2022, A5E37100388-012
In this menu you can:
• Increase the pump capacity using the <→> or <↑> key
• Decrease the pump capacity using the <↓> key
Keep new val.
8341
• Store the set pump capacity using the <ENTER> key
• Cancel the input using the <ESC> key.
Changes to the pump capacity are shown on the flowmeter and
directly in the menu display by the message "o.k." or "not o.k.".
In this menu you can:
• Increase the contrast using the <→> or <↑> key. This darkens
Keep new val.
• Decrease the contrast using the <↓> key. This brightens the
8342
• Store the set contrast using the <ENTER> key
• Cancel the input using the <ESC> key.
the characters.
characters.
Functions
8.4 Configuration
133