Configuration: Inputs/Outputs/Pump - Siemens ULTRAMAT 23 Series Equipment Manual

Functions
8.4 Configuration
843
Figure 8-7 Overview of configuration of analyzer tests
8.4.1

Configuration: Inputs/outputs/pump

Analog outputs
Assign relays
Binary/Sync inputs
Pump ON/OFF modes
136
Test:displ./keys/flow
Inputs/outputs
Chopper/IR source
RAM monitor
843
Test analog outputs
Test of relays
Test ext. sol. valve
Test of inputs
8432
Test of relays
Relay number: X
Condition: XXXXXXXXX
Press ESC to cancel
84322
Test of binary inputs
Press ESC to cancel
Active input:
NONE
843242
Optional board
not found!
Press ESC to return
843242a
Chopper: ON
IR source: ON
8433
You can use this menu to assign certain functions to the follow‐
ing elements:
• Relays
• Inputs and outputs
841
Furthermore, the following settings can be made using this
menu:
• Synchronization of several analyzers
• Pump response with AUTOCAL and in measuring mode
Test of display
Test of keys
Test of flow switch
8431
Analog 1: XX.XX mA
Analog 2: XX.XX mA
Analog 3: XX.XX mA
Analog 4: XX.XX mA
84321
XXXXX vpm NNNNNZV
XXXXX vpm NNNNNOFF
XXXXX vpm NNNNNSV
XXXXX % O2 OFF
84323
CAL/Pump/Sync inputs
Binary inputs
84324
Equipment Manual, 04/2022, A5E37100388-012
Test in progress
Press ESC to cancel
84311
Test of keys
Time left: XX sec
Pressed key:
No key pressed
84312
Test of flow sensor
Flow O.K.
Press ESC to cancel
84313
Test of C/P/S inputs
Active input:
none
Press ESC to cancel
843241
ULTRAMAT 23