Siemens ULTRAMAT 23 Series Equipment Manual page 152

Functions
8.4 Configuration
Configuration: Special functions: Factory data/reset/units: Reset
Warning! Analyzer is
set to warm-up mode!
Press ENTER to cont.
Press ESC to cancel
Configuration: Special functions: Factory data/reset/units: Change units
Unit for SO2
set:
MR min:
MR max:
Unit for SO2
set
MR min:
MR max:
Note
The full-scale values may assume unusual values as a result of the component-specific
conversion factors. Subsequent adaptations can be carried out as described in
section Parameters: Measuring ranges: Setting measuring ranges (Page 129). In addition, you
should also check these parameters following this change:
• Setpoints of the calibration gases (section Calibration: Infrared component: Set span gas
values (Page 116))
• Settings for the limits (section Parameters: Limits (Page 130)).
152
You can use this function to restart the analyzer.. When you select
this function, you will be warned (see
adjacent display) that the analyzer initially runs through a warm-
up phase following the restart and is thus unavailable for meas‐
84242
urements for a certain time.
The <ENTER> key initiates the restart with the warm-up phase.
Triggering of the restart can be prevented here using the <ESC>
key.
In the second line of this menu display, you can change the fac‐
tory-set units of the measured components.
mg/m
400 - 10%
After changing the unit, the display of the 'MB min' and 'MB max'
2000 + 10%
parameters is adapted accordingly.
84243a
This dialog is specific to the component.
: vpm
148 - 3%
757 + 3%
84243a
Equipment Manual, 04/2022, A5E37100388-012
ULTRAMAT 23