Input/Turbine Speed Sensor Removal/Installation; Intermediate Sensor Inspection; Intermediate Sensor Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION

1. Remove the automatic transaxle. (See
INSTALLATION.)
2. Remove the input/turbine speed sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
3. Install the input/turbine speed sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
4. Install the automatic transaxle. (See
INSTALLATION.)
End Of Sie

INTERMEDIATE SENSOR INSPECTION

On-Vehicle Inspection
1. Disconnect the terminal component No.2
connector.
2. Measure resistance between the terminals C and
D.
• If not as specified, inspect the intermediate
sensor. (See K2–86 Inspection of Individual
Part.)
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Connect the terminal component No.2 connector.
Inspection of Individual Part
1. Remove the intermediate sensor. (See
2. Measure resistance between the terminals of the
intermediate speed sensor.
• If not as specified, replace the intermediate
sensor.
• If it is normal, replace the harness.
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Install the intermediate sensor. (See
INTERMEDIATE SENSOR REMOVAL/
INSTALLATION.)
End Of Sie

INTERMEDIATE SENSOR REMOVAL/INSTALLATION

1. Remove the automatic transaxle. (See
INSTALLATION.)
2. Remove the intermediate sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
3. Install the intermediate sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
4. Install the automatic transaxle. (See
INSTALLATION.)
End Of Sie
K2–86
AUTOMATIC TRANSAXLE
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
TERMINAL COMPONENT No.2
K2–86 INTERMEDIATE SENSOR
K2–86
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
A C E G
B D F H
REMOVAL/INSTALLATION.)
A6E571421550203
A6E571417400202
A6E5714W117
A6E5714W118
AMU0517W051
A6E571417400203