Neutral Switch Inspection - Mazda Mazda6 Workshop Manual Supplement

NEUTRAL SWITCH INSPECTION

Note
• Perform the following test only when directed.
Continuity Inspection
1. Inspect for continuity between the neutral switch
terminals using an ohmmeter.
• If the neutral switch is okay, but the CPP/PNP
PID is out of specification, perform the "Circuit
Open/Short Inspection"
• If not as specified, replace the neutral switch.
Specification
Condition
Transmission
Rod pushed In neutral
Other
Except above
Circuit Open/Short Inspection
1. Inspect for open/short circuit in the following wiring harnesses.
• If there is open/short circuit, repair or replace wiring harnesses.
Open circuit
• Signal circuit
— Neutral switch terminal A and PCM terminal 56
• GND circuit
— Neutral switch terminal B and GND
Short circuit
• Signal circuit
— Neutral switch terminal A and PCM terminal 56 to GND
End Of Sie
CONTROL SYSTEM
O
O
: Continuity
Terminal
A
B
O O
A6E40702035
PUSH
ROD
A6E404017640201
B A
F2
A6E40702036
F2–69