Mazda Mazda6 Workshop Manual Supplement page 676

Clip Disassembly Note
1. Mark the drive shaft and outer ring for proper
assembly.
Caution
• Mark with paint; do not use a punch.
2. Remove the clip.
Snap Ring Disassembly Note
1. Mark the drive shaft end and inner ring for proper
reassembly.
Caution
• Mark with paint; do not use a punch.
2. Remove the snap ring using snap-ring pliers.
Balls, Inner Ring, Cage Disassembly Note
1. Mark the inner ring and cage for proper reassembly.
Caution
• Mark with paint; do not use a punch.
2. Turn the cage approximately 30 degrees and
pull the cage and balls from the inner ring.
ABS Sensor Rotor Assembly Note
1. Install the ABS sensor rotor to the drive shaft
using the SSTs.
M–46
REAR DRIVE SHAFT
49 B025 009A
MARK
MARK
30°
49 B025 006A
ABS SENSOR
ROTOR
A6E6316W010
A6E63172005
A6J63172006
20.7 mm
{0.81 in}
A6E63172008