Mazda Mazda6 Workshop Manual Supplement page 669

4. Fill the boot with the repair kit grease.
5. Adjust clearance A by turning the adjusting bolt of the SST.
Clearance A
3.2 mm {0.13 in}
6. Crimp the wheel side big boot band using the SST.
7. Verify that clearance B is within the specification.
• If clearance B is more than the specification, reduce clearance A of the SST and crimp the boot again.
• If clearance B is less than the specification, replace the boot band, increase clearance A of the SST and
crimp the new boot.
Clearance B
2.4—2.8 mm {0.095—0.110 in}
8. Verify that the boot band does not protrude from the boot band installation area.
• If it does, replace the boot band and repeat Steps 7 and 8.
End Of Sie
FRONT DRIVE SHAFT (4WD) DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
1 Boot band (wheel side)
(See M–35 Boot Band (Wheel Side) Disassembly
Note)
(See M–38 Boot Band (Wheel Side) Assembly
Note)
2 Boot band (transaxle side)
(See M–35 Boot Band (Transaxle Side)
Disassembly Note)
(See M–38 Boot Band (Transaxle Side) Assembly
Note)
3 Outer ring
(See M–40 Outer Ring Disassembly
(See M–41 Outer Ring Assembly
4 Snap ring
(See M–40 Snap Ring, Tripod Joint Disassembly
Note)
(See M–41 Tripod Joint, Snap Ring Assembly
FRONT DRIVE SHAFT
5
6
7
8
Note)
Note)
9
10
Note)
Tripod joint
(See M–40 Snap Ring, Tripod Joint Disassembly
Note)
(See M–41 Tripod Joint, Snap Ring Assembly
Free ring
Boot
(See M–40 Boot Disassembly
(See M–41 Boot Assembly Note)
ABS sensor rotor (with ABS)
(See M–36 ABS Sensor Rotor (With ABS)
Disassembly Note)
(See M–36 ABS Sensor Rotor (With ABS) Assembly
Note)
Shaft and ball joint component
Dynamic damper
(See M–41 Dynamic Damper Assembly
A6E631525500202
M
A6E0313W043
Note)
Note)
Note)
M–39