Mazda Mazda6 Workshop Manual Supplement page 833

INTERIOR LIGHTING SYSTEM, WIPER AND WASHER
CARGO COMPARTMENT LIGHT INSPECTION
1. Remove the cargo compartment light. (See
INSTALLATION)
2. Inspect for continuity between the cargo
compartment light terminals using an ohmmeter.
• If not as specified, replace the cargo
compartment light.
Switch position
DOOR
OFF
End Of Sie
REAR WIPER MOTOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See
INSTALLATION.)
3. Remove the liftgate lower trim. (See
4. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Rear wiper motor
4 Outer bushing
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See
REAR WIPER ARM AND BLADE
ADJUSTMENT.)
End Of Sie
REAR WIPER MOTOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See
3. Disconnect the rear wiper motor connector.
4. Connect battery positive voltage to the rear wiper motor terminal A, and ground the rear wiper motor terminal B
to a bare metal part of the vehicle.
T–22
T–21 CARGO COMPARTMENT LIGHT REMOVAL/
: Bulb
Terminal
A B
A6A81141119
WIPER AND WASHER
T–23 REAR WIPER ARM AND BLADE REMOVAL/
S–24 LIFTGATE LOWER TRIM
T–24
S–24 LIFTGATE LOWER TRIM
A
OFF
DOOR
B
REMOVAL/INSTALLATION)
3
1
REMOVAL/INSTALLATION)
A6E811451441202
A B
* *
A6J81141112
A6E811667450201
4
3.92—6.86
{40.0—69.9,
34.8—60.6}
2
N·m {kgf·cm, in·lbf}
A6E81161110
A6E811667450202