Control System; Pcm Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

PCM REMOVAL/INSTALLATION

Note
• For replace the PCM, setup the WDS and perform the following.
— "PCM configuration" (See
— "Correction after Parts Installation" (See
European (L.H.D.) Specs.
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
1 PCM connector
2 PCM
3. Install in the reverse order of removal.
U.K. Specs.
1. Disconnect the negative battery cable.
2. Remove the front side trim (left-side).
3. Partially peek back the flower covering.
4. Remove in the order indicated in the table.
1 Set bolt
(See F2–64 Set bolt removal
(See F2–64 Set bolt installation
2 PCM cover
3 PCM connector
4 PCM
5. Install in the reverse order of removal.
Set bolt removal note
1. Using a chisel and a hammer, cut a groove on the head of the set bolt so that a screwdriver can be inserted.
2. Loose the set bolt using an impact screwdriver or
pliers.
Set bolt installation note
1. Install a new set bolt and tighten it until the neck
of the bolt is cut.
F2–64

CONTROL SYSTEM

CONTROL SYSTEM
F2–68 PCM CONFIGURATION.)
F2–34 Correction after Parts
note)
note)
Installation.)
2
7.8—10.8
{80—110, 69.1—95.5}
1
3.0—5.4
{31—55, 26.6—47.7}
2
1
7.8—10.8
{80—110,
69.1—95.5}
3
3.0—5.4
{31—55, 26.6—47.7}
SET BOLT
CHISEL
SET BOLT
A6E404018881207
7.8—10.8
{80—110, 69.1—95.5}
N·m {kgf·cm, in·lbf}
A6E40402022
7.8—10.8
{80—110, 69.1—95.5}
4
N·m {kgf·cm, in·lbf}
A6E40402023
A6E40402020
CUT
A6E40402021