Oil Filter; Oil Filter Replacement; Oil Cooler; Oil Cooler Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

OIL FILTER REPLACEMENT

MZR-CD (RF Turbo)
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Remove the oil filter using the oil filter wrench.
4. Use a clean rag to wipe off the mounting surface
on the oil filter.
5. Apply clean engine oil to the O-ring of a new oil
filter.
6. Using the oil filter wrench, tighten the filter
according to the installation procedure indicated
on the side of the filter or packing box.
7. Start the engine and inspect for oil leakage.
• If the oil leaks, specify the faulty part and
repair or replace it.
8. Inspect the oil level. (See
INSPECTION.)
9. Install the under cover.
End Of Sie

OIL COOLER REMOVAL/INSTALLATION

MZR-CD (RF Turbo)
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the engine coolant.
4. Remove in the order indicated in the table.
5. Install in the reverse order of the removal.
6. Refill the engine coolant.
7. Start the engine and inspect for oil leakage.
• If the oil leaks, specify the faulty part and repair or replace it.
8. Inspect the oil level. (See
INSPECTION.)
.
1 Water hose
2

Oil cooler

End Of Sie
OIL FILTER, OIL COOLER

OIL FILTER

D–8 ENGINE OIL
OIL COOLER
D–8 ENGINE OIL
1
R
OIL OIL
34—44
{3.5—4.4,
25.4—31.8}
2
OIL OIL R
A6E331414300201
OIL FILTER
WRENCH
OIL FILTER
A6E3314W100
A6E331819900201
1
N·m {kgf·m, ft·lbf}
A6E3318W100
D–9
D