Mazda Mazda6 Workshop Manual Supplement page 680

5. After removing the front side of the differential
mount, gradually lower the jack and tilt the front
side of the differential downward.
6. Pull the companion flange off using the SST.
7. Remove the oil seal from the differential carrier
using a screwdriver or similar tool.
8. Apply differential oil to the new oil seal lip.
9. Install the new oil seal to the differential carrier
using the SST.
10. Install the companion flange to the drive pinion.
11. Jack up the differential and install the front side of
the differential mount.
Tightening torque
74.5—104.9 N·m {7.6—10.7 kgf·m, 55.0—77.3
ft·lbf}
12. Install the washer and a new locknut.
13. Tighten the locknut to the specified torque using
the SST.
Tightening torque
167—226 N·m {17.1—23.0 kgf·m, 124—166
ft·lbf}
14. Install the propeller shaft. (See
SHAFT REMOVAL/INSTALLATION)
15. Add the specified differential oil from the filler
plug. (See M–48 DIFFERENTIAL OIL
REPLACEMENT)
End Of Sie
M–50
REAR DIFFERENTIAL
L–5 PROPELLER
DIFFERENTIAL
JACK
49 0839 425C
49 W011 102
49 S120 710
A6E63192042
A6A63192043
A6A63192006
A6A63192007