Vehicle Speedometer Sensor (Vss) Inspection; Vehicle Speedometer Sensor (Vss) Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

VEHICLE SPEEDOMETER SENSOR (VSS) INSPECTION

On-Vehicle Inspection
1. Disconnect the terminal component No.2
connector.
2. Measure resistance between the terminals A and
B.
• If not as specified, inspect the VSS sensor.
(See K2–87 Inspection of Individual
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Connect the terminal component No.2 connector.
Inspection of Individual Part
1. Remove the VSS sensor. (See
INSTALLATION.)
2. Measure resistance between the terminals of the
VSS speed sensor.
• If not as specified, replace the VSS sensor.
• If it is normal, replace the harness.
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Install the VSS sensor. (See
SPEEDOMETER SENSOR (VSS) REMOVAL/
INSTALLATION.)
End Of Sie

VEHICLE SPEEDOMETER SENSOR (VSS) REMOVAL/INSTALLATION

1. Remove the automatic transaxle. (See
INSTALLATION.)
2. Remove the VSS sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
3. Install the VSS sensor. (See Automatic Transaxle Workshop Manual JA5A-EL.)
4. Install the automatic transaxle. (See
INSTALLATION.)
End Of Sie
AUTOMATIC TRANSAXLE
Part.)
K2–87 VEHICLE SPEEDOMETER SENSOR (VSS) REMOVAL/
K2–87 VEHICLE
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
TERMINAL COMPONENT No.2
A C
B D
A6E571417400204
A6E5714W117
E G
F H
A6E5714W118
AMU0517W051
A6E571417400205
K2–87
K2