Mazda Mazda6 Workshop Manual Supplement page 589

STEP
10 INSPECT INTERMEDIATE SENSOR
CONNECTOR FOR POOR CONNECTION
• Disassemble the transaxle.
• Disconnect intermediate sensor connector.
• Check for poor connection (damaged, pulled-
out terminals, corrosion, etc.).
• Are terminals okay?
11 INSPECT INTERMEDIATE SENSOR
RESISTANCE
• Measure resistance between intermediate
sensor.
• Is resistance within 513—627 ohms between
intermediate sensor connector terminal A and
B (part side)?
12 VERIFY TROUBLESHOOTING OF DTC P0715
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from memory using WDS or
equivalent.
• Drive vehicle with vehicle speed 40 km/h {25
mph} or above and engine speed 1500 rpm or
above for 2 second or more
• Repeat Step ii two times.
• Is same DTC present?
13 VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
(See K2–124 AFTER REPAIR
• Is there any DTC present?
End Of Sie
K2–174
ON-BOARD DIAGNOSTIC
INSPECTION
PROCEDURE.)
Yes Go to next step.
No Repair terminals, then go to Step 12.
Yes Repair or replace coupler component, then go to next step.
No Replace intermediate sensor, then go to next step.
Yes Replace TCM, then go to next step.
(See K2–96 TCM REMOVAL/INSTALLATION.)
No Go to next step.
Yes Go to applicable DTC inspection.
No Troubleshooting completed.
ACTION