Mazda Mazda6 Workshop Manual Supplement page 775

REAR STABILIZER REMOVAL/INSTALLATION (4WD)
1. Remove the rear auto leveling sensor.
(See T–20 REAR AUTO LEVELING SENSOR
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset.
43.1—60.8
{4.40—6.19,
31.8—44.8}
3
RUBBER
GREASE
.
1 Stabilizer control link
2 Coil spring component (One side only)
3 Stabilizer bracket
4 Bushing
Bolt (Differential Front Side) Removal Note
1. Disconnect differential oil temperature sensor connector and 4WD solenoid connector.
2. Support the differential with a jack as shown in
the figure.
3. Remove the bolt.
REAR SUSPENSION
REMOVAL/INSTALLATION.)
43.1—60.8
{4.40—6.19,
31.8—44.8}
4
A
6
74.5—104.9
{7.60—10.69, 54.95—77.37}
43.1—60.8
{4.40—6.19,
31.8—44.8}
A
1
5
5 Bolt (Differential front side)
(See R–13 Bolt (Differential Front Side) Removal
Note)
(See R–14 Bolt (Differential Front Side) Installation
Note)
6 Rear stabilizer
A6E741628100201
2
75.5—94.5
{7.70—9.63, 55.7—69.6}
N·m {kgf·m, ft·lbf}
A6E74162007
JACK
A6E74162011
R–13
R