Mazda Mazda6 Workshop Manual Supplement page 836

REAR WASHER NOZZLE ADJUSTMENT
1. Insert a needle or an equivalent tool into the spray
hole of the rear washer nozzle and adjust the
nozzle direction as shown.
End Of Sie
REAR WASHER HOSE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the washer tank.
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove joint pipe C from the body.
7. Remove the A-pillar trim.
8. Remove rear washer hose No.2 from clip A.
9. Remove clips B from the body.
10. Remove rear washer hose No.2 and joint pipes B.
11. Remove the D-pillar trim.
12. Remove the liftgate upper trim. (See
LIFTGATE UPPER TRIM REMOVAL/
INSTALLATION)
WIPER AND WASHER
REAR
WASHER
HOSE
NO.1
CLIP
REAR
WASHER
S–23
HOSE
NO.2
JOINT PIPE
GLASS
END LINE
7 {0.3}
GLASS
END LINE
a
JOINT
PIPE A
CLIP
JOINT
CLIP A
PIPE B
a
CLIP B
A6E811667511202
13 {0.5}
28 {1.1}
mm {in}
A6E81161118
A6E811667470201
A6E81161148
JOINT PIPE C
T
A6E81161149
T–25