Mazda Mazda6 Workshop Manual Supplement page 658

Bolt (Trailing Link (Front)) Installation Note
Warning
• Be sure that the trailing link and the knuckle component are supported securely with a jack.
Otherwise, the trailing link and/or the knuckle component may fall, causing death or injury, or
vehicle damage.
1. Support the trailing link and the knuckle
component with a jack.
2. Tighten the bolts at the trailing link (front).
Rear Coil Spring Installation Note
1. Install the coil spring so that its small diameter
end points downward.
2. Set a jack to the bottom of the lower arm, and jack
it up gradually.
Warning
• Be careful when installing the coil spring,
as it may fly out by spring force, causing
death or injury, or vehicle damage.
3. Install the lower arm bolts (outer).
Locknut Installation Note
1. Install a new locknut and stake it as shown.
End Of Sie
M–28
REAR AXLE
0.5 mm {0.02 in} OR MORE
JACK
LARGE
DIAMETER
LOWER SIDE
SMALL
DIAMETER
A6E63142103
A6E63142106
A6E0312W015