Supplemental Service Information - Mazda Mazda6 Workshop Manual Supplement

SUPPLEMENTAL SERVICE INFORMATION

• The following changes have been made since publication of the Mazda6 Workshop Manual (1730-1*-02C).
Power brake unit
• Removal/installation procedure has been modified.
Vacuum switch (MZR-CD (RF Turbo))
• Inspection procedure has been added.
• Removal/installation procedure has been added.
Vacuum pump (MZR-CD (RF Turbo))
• Inspection procedure has been added.
• Removal/installation procedure has been added.
Front brake (disc)
• Inspection procedure has been modified.
• Removal/installation procedure has been modified.
Disc pad (front)
• Replacement procedure has been modified.
Parking brake (lever type)
• Adjustment procedure has been modified.
DSC HU/CM
• Inspection procedure has been modified.
Combine sensor (Forward-G sensor)
• Inspection procedure has been modified.
On-board diagnostic (ABS/TCS)
• 4WD and MZR-CD (RF Turbo) have been added.
End Of Sie
PRECAUTION (BRAKES)
Wheels and Tires Removal/Installation
1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a
wheel is removed, tighten it to 88—118 N·m {9.0—12.0 kgf·m, 65.0—87.0 ft·lbf}.
Brake Lines Disconnection/Connection
Caution
• Brake fluid will damage painted surfaces. If brake fluid does get on a painted surface, wipe it off
immediately.
1. Tighten the brake pipe flare nut using the SST (49 0259 770B). Be sure to modify the brake pipe flare nut
tightening torque to allow for use of a torque wrench-SST combination.
• If any brake line has been disconnected anytime during the procedure, add brake fluid, bleed the brakes,
and inspect for leakage after the procedure has been completed.
Connectors Disconnection
1. Disconnect the negative battery cable before doing any work that requires handling of connectors. Reconnect
the negative battery cable only after the work is completed.
ABS, ABS/TCS, or DSC Components Operations
1. Make sure that there are no DTCs in the ABS, ABS/TCS, or DSC memory after working on ABS, ABS/TCS or
DSC components.
• If there are any DTCs in the memory, clear them.
End Of Sie
P–10
OUTLINE , GENERAL PROCEDURES
OUTLINE
GENERAL PROCEDURES
A6E690201020205
A6E691001020201