Transaxle Fluid Temperature; Input/Turbine Speed Sensor Inspection - Mazda Mazda6 Workshop Manual Supplement

TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION
1. Remove the automatic transaxle. (See
INSTALLATION.)
2. Disassemble the automatic transaxle, and then remove the TFT sensor. (See Automatic Transaxle Workshop
Manual JA5A-EL)
3. Install a TFT sensor, and then assemble the automatic transaxle. (See Automatic Transaxle Workshop Manual
JA5A-EL)
4. Remove the automatic transaxle. (See
INSTALLATION.)
5. Carry out the line pressure test. (See
6. Inspect the operation of the TR switch. (See
7. Inspect the operation of the selector lever. (See
8. Carry out the mechanical system test. (See
9. Carry out the road test. (See
End Of Sie

INPUT/TURBINE SPEED SENSOR INSPECTION

On-Vehicle Inspection
1. Disconnect the terminal component No.2
connector.
2. Measure resistance between the terminals E and
F.
• If not as specified, inspect the input/turbine
speed sensor. (See
Individual Part.)
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Connect the terminal component No.2 connector.
Inspection of Individual Part
1. Remove the input/turbine speed sensor. (See
INSTALLATION.)
2. Measure resistance between the terminals of the
input/turbine speed sensor.
• If not as specified, replace the input/turbine
speed sensor.
• If it is normal, replace the harness.
Resistance (ATF temperature: 20 °C {68 °F})
513—627 ohms
3. Install the input/turbine sensor. (See
INPUT/TURBINE SPEED SENSOR REMOVAL/
INSTALLATION.)
End Of Sie
AUTOMATIC TRANSAXLE
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
K2–99 AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/
K2–72 Line Pressure
K2–80 TRANSAXLE RANGE (TR) SWITCH
K2–117 SELECTOR LEVER
K2–72 MECHANICAL SYSTEM
K2–75 ROAD TEST.)
K2–85 Inspection of
K2–86 INPUT/TURBINE SPEED SENSOR REMOVAL/
K2–86
Test.)
INSPECTION.)
TEST.)
TERMINAL COMPONENT No.2
A C
B D
A6E571419010203
INSPECTION.)
A6E571421550202
A6E5714W117
E G
F H
A6E5714W118
AMU0517W051
K2–85
K2