Mazda Mazda6 Workshop Manual Supplement page 875

CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system.
3. Remove the shroud panel.
Caution
• If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and
abnormal noise will occur. Always immediately plug all open fittings after removing any
refrigeration cycle parts to keep moisture or foreign material out of the cycle.
4. Remove in the order indicated in the table. Do not
allow compressor oil to spill.
1 Cooler pipe No.1
(See U–13 REFRIGERANT LINES REMOVAL/
INSTALLATION)
(See U–13 REFRIGERANT LINES REMOVAL/
INSTALLATION)
2 Cooler pipe No.2
(See U–13 REFRIGERANT LINES REMOVAL/
INSTALLATION)
(See U–13 REFRIGERANT LINES REMOVAL/
INSTALLATION)
3 Condenser
(See U–12 Condenser Installation
5. Install in the reverse order of removal.
6. Perform the refrigerant system performance test.
Condenser Installation Note
1. When installing a new condenser, add a supplemental amount of ATMOS GU10 compressor oil inlet the
refrigerant cycle.
Supplemental amount (approximate quantity)
35 ml {35 cc, 1.2 fl oz}
End Of Sie
U–12
BASIC SYSTEM
.
Note)
3
R
1
R
6.86—9.80
{70.0—99.9, 60.8—86.7}
N·m {kgf·cm, in·lbf}
A6E851661480201
2
A6E8516W013