Northern Telecom NAC User Manual page 91

Table 5-1
Fatal error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Terminal control block creation failed"
display
No available memory was found.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system. Reboot the system to verify that the system is
configured with the correct amount of memory. If no memory problem is uncovered and the
problem persists, call your Northern Telecom service representative.
"Terminal control block key creation failed"
display
No available memory was found.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system. Reboot the system to verify that the system is
configured with the correct amount of memory. If no memory problem is uncovered and the
problem persists, call your Northern Telecom service representative.
"Terminal control semaphore 'get' operation failed"
display
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Terminal control semaphore initialization failed"
display
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Terminal control semaphore key creation failed"
display
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Terminal control semaphore 'release' operation failed"
display
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Uterm_cntrl.c
Uterm_cntrl.c
Udisp_sema.c
Udisp_sema.c
Udisp_sema.c
Udisp_sema.c
NAC error messages 5-41