Northern Telecom NAC User Manual page 111

Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Can not open trace file"
naclink
The trace log file cannot be opened.
Shut down and restart the system. Repeat the operation, if the problem persists, then call your
Northern Telecom service representative.
"can not write to APPL pipe –"
<Task>
Message intended for a specific application could not be passed to that application. This can
be caused by timing problems and should clear up on its own.
Look for other recent messages relevant to this message. If the messages found are serious,
shut down the system and call your Northern Telecom service representative. Otherwise, ignore
this message.
"Can not write to APPL – %s %d"
<Task>
A system error has occurred.
Look for other recent messages relevant to this message. If the messages found are serious,
shut down the system and call your Northern Telecom service representative. Otherwise, ignore
this message.
"cannot access shared memory file"
naclink
A file cannot be found.
Verify that the NAC installation had no errors. If so, then call your Northern Telecom service
representative. Otherwise, reinstall the NAC system. Call your Northern Telecom
representative if the problem persists.
"Cannot acknowledge pipe: %s, rc = %d"
display
A variable has reached an illegal state.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system and call your Northern Telecom service
representative.
"Cannot add ACD–DN element: out of memory"
cquery
Either insufficient memory was installed in the system, irregular system activities occurred, or
a software error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system and call your Northern Telecom service
representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Ucom_hdl.c
<Module>
<Module>
Uapp_smif.c
Usupmsg.c
Ucquery.c
NAC error messages 5-61