Northern Telecom NAC User Manual page 61

Table 5-1
Fatal error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Cannot start %s – execv failed"
MAPA Controller
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"can't find dependent"
MAPA Controller
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"can't open input pipe"
nccrcv
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"could not attach shared memory"
MAPA Monitor
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"Could not open SUPMSG_DIR dir!"
display
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"Could not open SUPMSG_IN dir!"
display
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type) and reinstall the system
if they are correct. Call your Northern Telecom service representative if the problem persists.
"Could not set terminal into raw mode"
display
A system error has occurred.
Review the Supervisor Display defined in the hardware configuration and make sure they are
correct. If they are, shut down the system and run "Test I/O Ports" from the System Diagnostics
menu. If the problem persists, call your Northern Telecom service representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
ctl_utils.c
ctl_master.c
Unccrcv.c
monitor.c
Usupmsg.c
Usupmsg.c
Uterm_setup.c
NAC error messages 5-11