Northern Telecom NAC User Manual page 76

5-26 NAC error messages
Table 5-1
Fatal error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Home path of user is not set correctly"
sys_rpts
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type). If they are correct, then
reinstall the NAC system. Otherwise, call your Northern Telecom service representative.
"Illegal command line argument."
cstats
Installation failed or the site has an improper version of the release materials.
Check your release materials (that is, version number and system type). If they are correct, then
reinstall the NAC system. Otherwise, call your Northern Telecom service representative.
"illegal instruction"
signal processor
Either insufficient memory was installed in the system, irregular system activities occurred, or
a software error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs, then call your Northern Telecom service representative.
"Improper access to database file."
LangServer
A database error has occurred.
Reinstall the hardware and software if there were errors during the most recent
installation/upgrade of the NAC system. If there were no errors during the installation/upgrade,
or if the problem persists after reinstallation call your Northern Telecom service representative.
"Internal Error"
display
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Internal Error"
mpsa
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"interrupt signal received"
signal processor
Either insufficient memory was installed in the system, irregular system activities occurred, or
a software error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs, then call your Northern Telecom service representative.
553-4011-510 Standard 1.0 November 1994
Module
Urpt_init.c
Ucstats.c
Usignal.c
lang.c
Upa_ntwk.c
Upa_ntwk.c
Usignal.c