Northern Telecom NAC User Manual page 141

Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Error reading xmit interval from SYSDB"
cstats
A database error has occurred.
Verify that the NAC installation had no errors. If so, then call your Northern Telecom service
representative.
"Error receiving acddata: rc = %d"
display
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system and call your Northern Telecom service
representative.
"Error receiving CC Message"
nccsend
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system and call your Northern Telecom service
representative.
"error receiving message"
nccrcv
A system error has occurred.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
"Error reopening local tty port"
linkread
There is a problem reopening the modem.
Check the modem to ensure it is the model supported. Make sure that the connection is set up
properly. If the problem persists, call your Northern Telecom service representative.
"Error reopening Remote Login port %s"
display
There is a problem reopening the modem.
Check the modem to ensure it is the model supported. Make sure that the connection is set up
properly. If the problem persists, call your Northern Telecom service representative.
"Error req_prog_resume(%s)"
display
A system error has occurred.
Repeat the operation to a network link from Parameter Administration. If the problem persists,
shut down and restart the system. Call your Northern Telecom service representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Ucstats.c
Unet_mgr.c
Uncc_ckpipe.c
Unccrcv.c
Usetty.c
Uremote.c
Upa_ntwk.c
NAC error messages 5-91