Table of Contents
Advertisement
5-118 NAC error messages
Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Network connection is not responding"
naclink
A system error has occurred.
Look for other recent messages and check their meaning. If these indicate other serious
problems then call your Northern Telecom service representative. Otherwise, no action is
required.
"Network connection mode not found, direct 9600 used"
linkread
Wrong baud rate is chosen.
The default baud rate, 9600, is used.
"Network error – bad file desc %d, node: %s"
cstats
A system error has occurred.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then shut down the system and call your Northern Telecom service
representative.
"Network error %d, node: %s."
cstats
A system error has occurred.
Look for other recent messages and check their meaning. If these indicate other serious
problems then call your Northern Telecom service representative. Otherwise, no action is
required.
"Network port is not a modem port – check MPSA %s"
linkread
The specified network port is not configured as a modem port.
Shut down the system. Choose MPSA and change the network port as a modem port. Restart
the system; if the problem persists, then call your Northern Telecom service representative.
"Never Received SVC UP Message from LINK READER"
naclink
A system error has occurred.
Look for other recent messages and check their meaning. If these indicate other serious
problems then call your Northern Telecom service representative. Otherwise, no action is
required.
553-4011-510 Standard 1.0 November 1994
Module
Unaclink.c
Ulinkread.c
Ucstats.c
Ucstats.c
Ulinkread.c
Ucom_hdl.c
Advertisement
Table of Contents
