Table of Contents
Advertisement
5-12 NAC error messages
Table 5-1
Fatal error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Could not set terminal into raw mode"
lib_usrif
A system error has occurred.
Review the Supervisor Display defined in the hardware configuration and make sure they are
correct. If they are, shut down the system and run "Test I/O Ports" from the System Diagnostics
menu. If the problem persists, call your Northern Telecom service representative.
"Couldn't allocate DB shared memory"
nccrcv
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Couldn't allocate DB shared memory"
nccrcv
Either insufficient memory was installed in the system, irregular system activities occurred, or
a system error was detected.
The task should begin its recovery process and will start again without user intervention. If the
problem reoccurs then call your Northern Telecom service representative.
"Database access failure –– table: langs"
display
A database error has occurred.
Reinstall the hardware and software if there were errors during the most recent
installation/upgrade of the NAC system. If there were no errors during the installation/upgrade,
or if the problem persists after reinstallation, call your Northern Telecom service representative.
"Database access failure –– table: langs"
mpsa
A database error has occurred. Do a database check to verify the integrity of the data. If this is
unsuccessful, reinstall the hardware and software (if there were errors during the most recent
installation/upgrade of the NAC system). If there were no errors during the installation/upgrade,
or if the problem persists after reinstallation, call your Northern Telecom service representative.
"Database access failure –– table: profile"
display
A database error has occurred.
Reinstall the hardware and software if there were errors during the most recent
installation/upgrade of the NAC system. If there were no errors during the installation/upgrade,
or if the problem persists after reinstallation, call your Northern Telecom service representative.
553-4011-510 Standard 1.0 November 1994
Module
uicommon.c
Uload_ncc.c
Unccrcv.c
Ulogin.c
<Module>
Ucmis_mmenu.c
Advertisement
Table of Contents
