Northern Telecom NAC User Manual page 153

Network administration center
Hide thumbs Also See for NAC:
Table of Contents

Advertisement

Table 5-2
Warning error messages
Error Message
Task
Explanation
Error Recovery Procedure
"Incorrect arguments: no command found"
Print_Admin
A system error has occurred. Re-install the hardware and software if there were errors during
the most recent installation/upgrade of the NAC system. If there were no errors during the
installation/upgrade or the problem persists after re-installation, call your Northern Telecom
representative.
"Incorrect baud_rate, 9600 is used"
linkread
Wrong baud rate was chosen.
The default baud rate 9600 is used. No user intervention is necessary.
"Incorrect baud_rate, direct 9600 used"
linkread
Wrong baud rate was chosen.
The default baud rate 9600 is used. No user intervention is necessary.
"Incorrect cquery id [%d] in msg – should be %d"
cquery
A system error has occurred.
The task should begin its recovery process and will start again without user intervention.
"Interrupt received while writing to Dev_out_pipe"
naclink
A variable has reached an illegal state.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
"invalid argument '%c'"
MAPA Client
A variable has reached an illegal state.
Ignore this message if this is an isolated incident. Otherwise, shut down and restart the system.
"invalid argument [%c]. Use: –p –m (–I –O –R)"
ft_server
A system error has occurred.
Repeat the operation, if the problem reoccurs, then shut down and restart the system. Repeat
the operation again, if the problem persists, call your Northern Telecom service representative.
"Invalid argument [%s] given"
ft_server
A system error has occurred.
Repeat the operation. If the problem reoccurs, then shut down and restart the system. Repeat
the operation again. If the problem still persists, call your Northern Telecom service
representative.
Network Administration Center System Administration and Maintenance Guide Product release 2
Module
Ulp_setup.c
Ulinkread.c
Ulinkread.c
Ucquery.c
Ucom_hdl.c
client.c
fxfr.c
ft_server.c
NAC error messages 5-103

Advertisement

Table of Contents
loading

Table of Contents